| 1. | When two parcels of air with different initial temperatures are mixed, the result is a mixture with a higher relative humidity .
当初始温度不同的二个气块混合时，结果是形成一个具有较高相对湿度的混合物 |
| 2. | When two parcels of air with different initial temperatures are mixed , the result is a mixture with a higher relative humidity
当初始温度不同的二个气块混合时，结果是形成一个具有较高相对湿度的混合物。 |
| 3. | Ceramic material had better performance than steel and copper and the shorter the stack , the lower the initial temperature for oscillation
而从热声振动的方式来看，强制振动比自激振动具有更低的起振温度。 |
| 4. | Then the key process parameters of laser bonding , including laser power , scanning velocity , and initial temperature , are obtained with the help of scanning experiments
运用该模型计算了不同的工艺参数条件下硅玻璃的温度场分布，并由此得出键合线宽。 |
| 5. | Studies the impact of nozzle aperture , initial temperature and pressure of spray water and initial air state on humidifying effects based on an orthogonal test
摘要通过正交试验确定了喷嘴孔径、喷水初温、喷水压力及空气初状态对加湿效果影响的显著程度。 |
| 6. | Quantitatively analyses the concrete influences on atomizing humidifying performance of the nozzle aperture , initial temperature and the pressure of spray water and the water - air ratio through a single factor experiment
通过单因素试验定量分析了喷嘴孔径、喷水初温、喷水压力以及水气比对雾化加湿的具体影响。 |
| 7. | Detail datum of the initial temperature distribution , radiation heating , microwave heating , hybrid heating and using the ( fd ) 2td method were given and compared with datum from experimentation
给出了初始温度随时间分布，辐射加热，微波加热，混合加热，采用( fd ) ~ 2td方法等情况下的数值模拟结果，并与原始实验结果进行了比对。 |
| 8. | Furthermore , how to get the surface heat flux of the billet by its surface temperature and initial temperature is a typical inverse heat conduction problem ( ihcp ) in the mathematical sense
在数学意义上，就是一个利用偏微分方程的初始条件和一个边界条件来求得另一个边界条件的问题，这又恰恰就是一个典型的逆热传导问题( ihcp ) 。 |
| 9. | Three aspects are studied : ? he temperature field and stress field of penstock during construction period ; ? the initial temperature and stress status of penstock before subjected to internal water pressure ; ( 3 ) the optimization of the penstock construction ; 3
同时给出了坝后背管蓄水前初始应力状况，提出了优化施工计划的原则和方法。对以后坝后背管混凝土的施工具有实际指导意义； 3 |
| 10. | The performance of catalyst beds was experimentally studied . the influence on decomposition was investigated with changing the mass flux through the cross of the catalyst bed and the initial temperature of the catalyst bed . the experimental results were compared with those of the numerical simulation
对过氧化氢催化床的催化性能进行了试验研究,分析了催化床床载、催化床初始温度对过氧化氢催化分解的影响,与一维情况下的数值仿真结果进行了对比。 |
